Help Center

Knowledgebase
Cable Rail hole sizing for powder coated posts
Posted by Keri G. on 19 May 2016 07:21 AM

Q: I have to powder coat my parts that means the hole diameter I drill for the Invisiware receivers will become smaller. Do you make a hole enlargement allowance to take into account the reducing of the hole diameter after powder coating? If so how much.



A: Thickness is nominally 0.004 inch per side, with maximum of 0.005 inch per side. When it comes to holes, it is on both sides. Add 0.01" to hole size.  Please verify with finish provider.  

(479 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).