Help Center

Knowledgebase
Standard Tolerances
Posted by Keri G. on 24 April 2008 06:52 PM
Standard Tolerances
Hole sizes are .015" – .025" over the listed dimensions unless specifically mentioned. Product ID and OD are produced within commercial dimensional tolerances. Bend tolerances and angle of bend are +/- 2º. Cutting tolerances on pipe and tube are +/- 1/16". Multiple bend tolerances are +/- 2º and +/- 1/8" center-to-center thru 2.50" OD and +/- 1/4" center-to-center above 2.50" OD.
(607 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).