Help Center

Knowledgebase
Double Splice-Lock™
Posted by on 18 September 2015 11:54 AM

Proven the best mechanical splice available for pipe and tubular railing field joints. 

Splice-Locks are most effective as a joint stiffener when used within 12" of a welded post or handrail bracket.

Splice-Locks have a similar shear strength as standard pipe but are not to be used in post assemblies.

DOUBLE-LOCK SPLICE-LOCK™ ASSEMBLY

  1. Drill 13⁄32" diameter hole for 3⁄8" screws or 11⁄32" hole for 5⁄16" screws. This clear hole should be centered 3⁄8" from the end of each pipe or tube for 3-3⁄4" Splice-Locks™ or 1-7⁄32" to center for 6"and 8" Splice-Locks™, as shown.
  2. Insert Splice-Lock™ into this first section.
  3. Insert and partially tighten the set screw.
  4. Slide other section to be joined over the Splice-Lock™.
  5. Insert second set screw and tighten both screws fully.

The Splice-Lock™ contacts the inside of the tube or pipe in four areas along its length to ensure alignment and
maximum strength.

Resultant action: Splice-Lock™ contacts inside of pipe or tube in four areas along the full length to ensure alignment and maximum strength.

Note: Both sections to be joined must have the same wall thickness.

Double Splice Lock
DOUBLE SPLICE-LOCK™ FOR PIPE AND ROUND TUBING

Double Splice Lock
Double Splice Lock
 DOUBLE SPLICE-LOCK™ FOR SQUARE TUBING

 
(1 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).