Help Center

Knowledgebase
Cable Cutting and Swaging Measurement Instructions for factory swaged cables only
Posted by on 26 July 2016 03:42 PM

The factory can cut cable and swage fittings on cables up to 60 feet in length.
Measure from one end of the cable run to the other and specify from inside post, outside post or center of mounting hole depending on what hardware is being used. In ordering, be sure to specify the hardware being used -- by part number -- and where each end post measurement is taken.

 

Measurements are taken from the back side of the post, at the end, using the following hardware:

Invisiware Receiver Invisiware Radius Ferrule Ultra-tec Clip-On Stop

Measure from back side of post

Measure from back side of post Measure from back side of post

If post is pipe or tubing, we will assume there will be a counterbore to a depth of .100", unless we are told otherwise. Pipe should be a minimum schedule 80. Tubing should have a wall thickness at least equivalent to schedule 80 pipe.

Measurements are taken from the inside surface of the post , using the following hardware -- Threaded Tabs (CRTT6B or CRTT8B), Fixed Tab (CRFT65A or B, CRFT85A or B) or Lag Eyes (CRLE6 or CRLE8)

Adjust-A-Jaw Adjust-A-Body Fixed Jaw

Measure from inside surface of post

Measure from inside surface of post

Measure from inside surface of post

If being mounted in any other way using the following hardware, measure from the center of the mounting hole. The mounting hole might be a hole drilled in an angle iron or a piece of flat bar welded onto the end post or it might be a tube fabricated by the customer and attached to the post.

Adjust-A-Jaw Adjust-A-Body with Threaded Eye Fixed Jaw

Measure from center of mounting hole.

Measure from center of mounting hole.

Measure from center of mounting hole.

Measurements are taken from the inside surface of the post, at the end using the following hardware.
Adjust-A-Body with Hanger Bolt Adjust-A-Body with Threaded Bolt

Threaded Stud into a Welded Receiver or into a Drilled and Tapped Hole in a Post -- minimum wall thickness of 1/4".

Measure from inside surface of post

Measure from inside surface of post

Measure from inside surface of post



Attachments 
 
 terminal_selection_sheet.pdf (272.85 KB)
(1 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).